wanting to install side step and protection in nerf bar area but have ?
j0114
Jeeper
- Posts
- 154
- Thanks
- 0
- Location
- birmingham
- Vehicle(s)
- 86 CJ7 Laredo Black
The Jeep was totally gone thru, 124k original miles on body,
New Crate engine and Trans, Weber Carb, Interior replaced back to stock, Dana 44 Rear, Dana 35 Front, 2.5 " Suspension Lift 1" body 33-12.50 Tires on Mickey Thompson Wheels, New Dupont Paint
Most of the new stuff attaches to the body as well between the fenders, and my body on my jeep is in great shape, so I am extremely hesitant to bolt a piece of metal against the body, but its not just half its almost every companies side steps,side protection has a piece that sits against the body, Im worried if i take it off the paint will be scratched or water will get between the body and the piece put on there and possibly cause rust, i had thought if i was going to install a pice that bolted to the body to have the body where the metal plate bolts to rhino lined,line x'd etc, but then im stuck with always having to run a side piece that attaches to the body,
I need some protection and i need it to have a step,
My jeep isnt tall, its just a 4in lift with 33's but my girl is about 5'3-5'4 so its a bid step for her to get in,
There is a small step there now that is similar to what came factory on tj's for example, but even that is right at the bottom of the rocker panel,
looking for suggestions and products
I need some protection and i need it to have a step,
My jeep isnt tall, its just a 4in lift with 33's but my girl is about 5'3-5'4 so its a bid step for her to get in,
There is a small step there now that is similar to what came factory on tj's for example, but even that is right at the bottom of the rocker panel,
looking for suggestions and products