1975 CJ5 body mount advice needed
Hi friends,
I've been working on an amateur restoration in my garage for a couple of years and have just sent the steel tub out for refurbish. My questions have to do with mounts.
1)I am looking at using polyurethane mounts specifically the Rugged Ridge kit #1-109-BL. Can anyone give me feedback on this kit or others that are similar?
2)I would like to use stainless fasteners. Regarding the bolts that would be visible on the floor and load bed, would Jeep have used hex cap screws or button head socket screws? Button heads seem more clean and appealing.
This Jeep will not be a show car but will be put into daily (fair weather mostly) service. We will use it as a convertible for cruising around a small city and for country roads. Occasionally it will pull a landscaping trailer filled with firewood. Occasionally it may plow some snow.
Am I doing the right thing by using polyurethane?
Thanks.
Dan
I've been working on an amateur restoration in my garage for a couple of years and have just sent the steel tub out for refurbish. My questions have to do with mounts.
1)I am looking at using polyurethane mounts specifically the Rugged Ridge kit #1-109-BL. Can anyone give me feedback on this kit or others that are similar?
2)I would like to use stainless fasteners. Regarding the bolts that would be visible on the floor and load bed, would Jeep have used hex cap screws or button head socket screws? Button heads seem more clean and appealing.
This Jeep will not be a show car but will be put into daily (fair weather mostly) service. We will use it as a convertible for cruising around a small city and for country roads. Occasionally it will pull a landscaping trailer filled with firewood. Occasionally it may plow some snow.
Am I doing the right thing by using polyurethane?
Thanks.
Dan