Bump stop extensions
IOPort51
NOT the voice of reason Jeep-CJ.com
- Posts
- 13,959
- Thanks
- 11
- Location
- Garland Texas
- Vehicle(s)
- 1977 cj-5
4.2 W/MC2100 carb, 4.0 head W/3 angle valves,SS Header,TFI ignition with MSB-6 offroad module,CS144 140 amp RPS alternator with remote regulator T-150,d-20,Dana 44 with OX lock and disk brakes. D-30 with Spartin locker,
skyjacker 2.5 lift?nitro shocks,31" BFG A/T off road.8000 lb Warn winch, original owner.=^)
2006 Toyota Tacoma
Ok so I did not eve think of this.
I have a 2 1/2" lift and I never did anything with the bump stops. I guess here in Dallas Co. there was not much for me to bottom out the shocks on. BUT after the trip to the mountains and the roughest terrain that the CJ or I have ever traveled, I am finding signs that I may have exceeded the range of the shocks a few times. The bottom mounts are bent downward a couple of degrees.
I am not finding a lot of information on dropping the bump stops or a lot of options from suppliers.
If anybody has any comments, hopefully with pictures, before I go off on a journey of spontaneous creativity?? I would appreciate the input.
I have a 2 1/2" lift and I never did anything with the bump stops. I guess here in Dallas Co. there was not much for me to bottom out the shocks on. BUT after the trip to the mountains and the roughest terrain that the CJ or I have ever traveled, I am finding signs that I may have exceeded the range of the shocks a few times. The bottom mounts are bent downward a couple of degrees.
I am not finding a lot of information on dropping the bump stops or a lot of options from suppliers.
If anybody has any comments, hopefully with pictures, before I go off on a journey of spontaneous creativity?? I would appreciate the input.