Which clutch?
Which clutch?
- Thread starter godzilla
- Start date
Torxhead
Always Off-Roading Jeeper
From what I have read of the forums a lots of guys go the Luk clutch. Plus, the price is good also.
gr8dain
Full Time Jeeper
Agreed. I liked the LuK I had so I just installed another. And yes, the price was good as well.
Last edited:
jp360cj
Old Time Jeeper
- Posts
- 1,119
- Thanks
- 1
- Location
- NC
- Vehicle(s)
- '77 CJ7, 360, 6.32 T18, D20, Narrowed Chevy D44 front, 9" rear
No difference in the clutch between the 258 and 360, so you can just get a stock replacement for your year and transmission. I'm running a 360 also and I went with a LUK of replacement based on many recommendations on forums. Only a couple hundred miles on it so far, but no complaints. I found the best price on Rock Auto and it was under $100 shipped.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Posts
- 11,554
- Thanks
- 11
- Location
- Frederick colorado
- Vehicle(s)
- 84 cj7, 91 cherokee, 78 chevy 3500 pu, 78 CJ7
dang i guess im the odd man out. i bought the Centerforce II clutch, like the others said the flywheel is specific to the engine but the clutch is the same just make sure the spline count is correct for the input shaft of the trans
- Posts
- 14,772
- Thanks
- 44
- Location
- Springfield, Missouri-U.S.A. Earth
- Vehicle(s)
- '85 CJ-7, 258/4.2L 6cyl. Bought new in 1985. Full cage, Warn 8274 winch, Ford 9" rear, front/rear Detroit Lockers w/4:88 R&P. T-5 tranny and 4:1 t'case. 33X12.50-15 BFG/AT, MSD ign, on board air---
Centerforce is LUK parts for the CJ clutches. 
I run the LUK
LG
I run the LUK
LG
RiverandSand
Senior Jeeper
I installed a LUK clutch kit and flywheel from Rockauto, this past weekend. Got it all for less than 200 bucks. The kit came with pressure plate, disc, throwout bearing, pilot bearing and alignment tool. Pretty good deal I thought.
