Stroker motor

Stroker motor
Az84cj7

Az84cj7

Active Jeeper
Posts
287
Thanks
0
Location
AZ
Vehicle(s)
84 cj7 Inline 6, mopar fuel injection , T5 trans, dana 300, Dana 44's
Anyone have some good or bad info on doing a i6 stroker motor.? I've been kicking it around.
 
I built a 4.7 stroker for my rig and improved the torque to the point that i snap stock front axles every time i get into a hard place. I even snapped a hardened shaft the last time i was out. Lots of info here. Jeep Strokers • Homepage Would i do it again? Yup.
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a donation.

Help support Jeep-CJ.com by making a donation.
Goal
$200.00
Earned
$0.00
This donation drive ends in
Donate
Back
Top Bottom
✖
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks