A

1983 CJ7 Driveshaft

Status
Not open for further replies.
1983 CJ7 Driveshaft

aglinks

Active Jeeper
Posts
317
Thanks
28
Location
Flagstaff, AZ
Vehicle(s)
‘83 CJ7, 4.8L Vortec, TF999, D300, AMC20, D30
Just a question that others may ask. Is the driveshaft custom for the 4" lift or stock length and what dif./trans. yokes?
 
Just a question that others may ask. Is the driveshaft custom for the 4" lift or stock length and what dif./trans. yokes?
The driveshaft was custom for my drivetrain. It is 1310 u-joints at both ends, 34.25" compressed, 39.25" extended.
 
Status
Not open for further replies.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a donation.

Help support Jeep-CJ.com by making a donation.
Goal
$200.00
Earned
$0.00
This donation drive ends in
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks