1940s Bantam trailer

1940s Bantam trailer

GoldenEagle36

Senior Jeeper
Posts
681
Thanks
0
Location
SW Pennsylvania
Vehicle(s)
1977 cj7 Golden Eagle 304,automatic, Quadra-trac, full restoration just "finished." 4 inch superlift, lift shackles in the front, sitting on some KM2 Mud terrians
1999 tj 4 cylinder ax5 trans 3 inches lift 31s
1956 Dj3a all original except axles and engine, Hurricane 4 cyl. 4x4 conversion, 27,500 original miles 58 Jeep-A-Trench cj5 8000 miles.
i have a TC3 Bantam Jeep Trailer and the guts for the ball are missing. is there some place where they sell guts?
 
Good advice above. Check the G503 forum under 1/4 ton trailers and the Mwillys forum.
From my recent readings on this in regards to my latest project an M100 trailer, you are very lucky to have the correct hitch regardless of needing some parts.:drool:
 
I've seen people use pintle hitch parts from tractor supply. But an original type setup is nice if that's what your looking for. Me I prefer function over form.
 

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a donation.

Help support Jeep-CJ.com by making a donation.
Goal
$200.00
Earned
$210.00
This donation drive ends in
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks