sending

  1. C

    Fuel sending unit

    My fuel gauge stopped working and I’m reading full open on my meter between the post in the sending unit to the ground lead. This is a relatively new sending unit but before I drop the tank (again) I want to have another unit in hand. Omix and Crown seem to be the most common suppliers. What...
  2. S

    Electric vs Mechanical Sending Unit

    My 83 CJ7 inline six 258 positions the water temperature sending unit on the top rear deck of the cylinder head. I believe the thread for this electrical sending unit is 1/8 NPT (correct?). Does anyone have a resource for a mechanical water temp sending unit / gauge that would fit this small...
  3. W

    Fuel tank sending unit

    Original tank and I plan on removing the old sending unit to put in a new one with electric fuel pump. Does that large plastic nut hold everything in? Any tips and is it worth replacing those rollover vent check valves? Sent from my iPhone using Tapatalk
  4. W

    Fuel tank sending unit

  5. JeeperChris

    Where is my temp sending unit??

  6. O

    Source for 3/8" feed & 1/4" return fuel tank sending unit?

    I've got an 82 CJ7 and it's been V8 swapped by the PO. I'm now doing a Hamilton FI conversion and the instructions call for a 3/8" feed line and 1/4" return. My sending unit appears to have 1/4" ID feed & 3/16" ID return hard lines coming out of it, if I'm measuring correctly. I am assuming the...
  7. O

    Source for 3/8" feed & 1/4" return fuel tank sending unit?

  8. Knighttime85

    Lets talk fuel tank sending units

  9. S

    82 jamboree fuel tank and sending unit

  10. S

    Oil leak at sending unit

    I've got an oil leak where the oil pressure sending unit is on the block. I've been researching trying to find out what all was involved to take the sending unit out and either clean or replace to stop the oil leak, but things are not matching up. Did the factory 86 CJ7's come with an...
  11. S

    Oil leak at sending unit

    I've got an oil leak where the oil pressure sending unit is on the block. I've been researching trying to find out what all was involved to take the sending unit out and either clean or replace to stop the oil leak, but things are not matching up. Did the factory 86 CJ7's come with an...
  12. 007

    Sending unit leak

    So my leak is around where the sending unit seats in tank. Does this look right? Does it need tightened and if so how? Or is it bound up and not seating correctly as a result? Sent from my iPhone using Tapatalk
  13. driver007

    Oil sending unit

    Will a BWD S330 oil sending unit work with my 76 CJ5 258?
  14. driver007

    Oil sending unit

    Will a BWD S330 oil sending unit work with my 76 CJ5 258?
  15. ThisGuyUKnow

    In tank High Pressure Fuel pump Prototype Sending Unit

    Onlyinajeepcj and I made an intank hi pressure fuel pump set up the other day. Ed did most of the work to give credit where it is due. There is one in tank setup I know of for sale commercially for over 250 bucks and it is basically a CJ sending unit that has had the pick up tube cut and has a...
  16. ThisGuyUKnow

    In tank High Pressure Fuel pump Prototype Sending Unit

    Onlyinajeepcj and I made an intank hi pressure fuel pump set up the other day. Ed did most of the work to give credit where it is due. There is one in tank setup I know of for sale commercially for over 250 bucks and it is basically a CJ sending unit that has had the pick up tube cut and has a...
  17. Jsooter

    Temperature sending unit

    I have the valve cover off to replace a leaking gasket and have decided to replace the temperature sending unit since it is not working 100% (I've bench-tested the temp/fuel gauges and they work great with a resistor). Since the sending unit is grounded through the head, should I use teflon...
  18. B

    Oil pressure sending unit

    After the nutter should I leave these wires hooked up i believe in all the stuff I read I thought it tied in with the manifold heater somehow.And I'm trying to keep the stuff not controlled by the computer. Just didn't know if i could keep the existing wire or if I had to run some new...
  19. B

    Temperature gauge Sending unit

    Anyone know where the sending unit for the temperature gauge goes on a 78 straight six? PO cut the heater hose and tried to put it in there. Needless to say it doesn't work. Lol
  20. B

    Temperature gauge Sending unit

    Anyone know where the sending unit for the temperature gauge goes on a 78 straight six? PO cut the heater hose and tried to put it in there. Needless to say it doesn't work. Lol
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks