advice

  1. F

    Misc. 82 Cj-7 Jeep advice

    Ok guys, need some advice on first Jeep project. Recently purchased an 82 Cj7 with the i6. Its a project for sure but body is in good shape with very little rust and it unknown at this point about the transmission but motor seems to be ok. I really want this thing fixed up to the point where...
  2. U

    New CJ-7 suspension advice

    I picked up an 85 CJ-7 a little while back and the PO had really no idea what the specs were on it, aside from the 94 4.0 that was in it. I'm trying to figure out some things with the suspension and thought I could get some help here. It has con-ferr shackles all around which are 6.5" from...
  3. Scout1067

    Rear axle advice

    I am fixing to pull the trigger on new one piece rear axles for my AMC 20. Igot the wife to agree to it[emoji16]. What do I need to measure to ensure I order the correct axles? I am looking at going with the Moser CJ-S one piece kit because I think that is the one I need. Sent from my...
  4. D

    "New" 74 CJ5

    Hello-- I am looking for some advice. I am picking up a 74 CJ5 this week. 258 Straight 6, 3 speed manual. I have owned YT/TJs in the past (1994, 2000, 2011) but finally pulled the trigger on my first CJ. Always been my favorite. I have some minor experience with repairs (replace radiator...
  5. olddaze

    New member seeking advice

    Hi all, I bought a 1984 CJ7 back in January and have been sorting though its problems. First, I guess it's best to paint ya a picture of what I have and work completed so far. 1984 CJ7 with a 4.2 and a stock 4 speed manual transmission. Replaced front & rear spring bushings, new heavier...
  6. CJ7JEEP1979

    Advice for Stewart Warner oil gauge please

    I picked my Jeep up from the shop today and everything is good to go but I need to replace my oil pressure gauge. It is pegged at 100 and when they hooked up a mechanical gauge under the hood the oil pressure is perfect and where it should be. They suggested I replace the stock electrical gauge...
  7. J

    Another gear advice post

    Hey, guys. Getting ready to regear and need some advice. I'm looking to add some pep and fun. Current setup: Built 304(about as much as can be), T176, AMC 20 rear/Dana 30 front, 2:73 gears, 33" tires. Driving habits: Never over 60mph. No rock climbing. Offroading is mostly trails and some mud...
  8. TnCJ

    Need advice on an engine please

    My 1980 Jeep's engine is getting tired. Slight knock on the bottom end, almost zero oil pressure at idle and 15 lbs running down the road. [and yes LG I verified pressure with another gauge lol] Sooo, I think its time for a rebuild. But after some searching I've found another CJ5 that was...
  9. TnCJ

    Need advice on an engine please

  10. C

    Newbie Advice

    I am looking to get a CJ jeep and work on it with my sons. We went looked one the other day 1981 CJ5 with 80k. The body was in decent shape (couple of rust spots/small holes). The motor ran good, especially for sitting all winter. But, the guys asking $6k I am just starting to look but...
  11. M

    New engine, any advice

    Hi all, Im looking at replacing my 304, and was considering a 360 instead. Any thoughts? I have 78' CJ7 with TH400 tranny and Quadra-track AWD, 32x11.5 tires, not sure on the gears. Thanks
  12. M

    New engine, any advice

  13. E

    Lift Advice for 84 CJ7

    New here been searching online for info reguarding yj spring conversion. When I purchased the jeep it had been converted over to yj springs. It appears to have a shackle lift but Im unsure if the springs are stock yj springs they are 5 leafs front/rear. Running some 32” and dont want to much...
  14. W

    Lift Kit Advice for CJ8

    Hey Jeepers new to the forum. I've had my 81' CJ8 for about 4 years now. It is pretty much stock with the 258 engine and all original suspension. Dual stick transfer case and weber carb are the only major mods. It did have original AC but it was taken out, not sure I will put it back in...
  15. T

    Rear main seal crankshaft issue/ need advice on next step

    Ok so I own a 1974 CJ5 that is for the most part in great condition. It was restored in 2001 by a PO and after restoration and some use it did some aging in a barn. Over the past couple years I have replaced a lot of the wearable items and gave it some TLC to get it back in reliable shape...
  16. T

    Rear main seal crankshaft issue/ need advice on next step

  17. N

    Advice on rear bumper with swing tire carrier...

  18. N

    Advice on lowering CJ7

    Need some opinions, I’ve got an 1980 CJ7, spring over ,lifted,on 37s. I’m going to but it back to more street friendly, spring under, with a 4in lift and 33s. My question is what order should I do it in. I know I’ve got to have the spring perches moved. Do I need to have the lift kit ready to...
  19. 8

    Need carb advice

  20. J

    Looking at this 1961 CJ5. Any advice would be appreciated.

    Tub is 8 years old, F134 engine, 3 speed, hi/lo transfer case, manual locking hubs, newer radiator, new rear main seal, new pinion seal and diff cover gaskets. D24 front, d44 rear, t90, new master cylinder, brakes, tires, steel and rubber lines. What's a fair offer? Sent from my SM-G965U using...
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks