350

  1. raser13

    350 pin out diagram help needed

    Hey guys and gals, i need your help. I'm working an putting a chevy 350 from a 1990 suburban into my CJ-5. I have most of the wiring diagrams for the motor and the ecu. As such i have most of the wiring re-ran since some of the wiring got chewed up by mice. Where i'm running into trouble is...
  2. raser13

    350 pin out diagram help needed

  3. T

    350 starters and flexplates

    Hi everyone, I recently picked up a '76 CJ7 with no engine, trans, t-case, or driveshafts. I have decided to put in a chevy 350 and th350. I already bought my transmission and dana 20 t-case. Now I am trying to figure out the flexplate and torque converter. The converter I want uses the larger...
  4. T

    350 starters and flexplates

  5. Super8mm

    Swapping a Iron Duke to a 350

    I found out recently while running up and down the coast of NC that that Iron Duke is not really a highway engine I am pondering getting a Chevrolet Crate Engine and was wondering if anyone has used them and what sort of luck did you have? Also did you go with carburetor or something like...
  6. Super8mm

    Swapping a Iron Duke to a 350

  7. M

    Cj7 engine swap

    Alright my 84 cj7 has a 304 in it. My dads been harassing me about putting a 350 in it. I dont know whether or not to rebuild the 304 or bite the bullet with the 350. Its got a 3 or 4 inch lift so it sits pretty high if that matters. Also leaning towards efi, any thoughts? Thanks
  8. M

    Cj7 engine swap

  9. raser13

    1990 350 queastions

    Hey guys and gals, I have a 350 out of donor 1990 suburban, that I got for free. It has the half carb half fuel injection thing On it. So far I have everything under the hood and the control box under the dash. Is there anything else from the inside wiring harness that I need? I'm yanking the...
  10. raser13

    1990 350 queastions

  11. raser13

    chevy 350 wiring, what all do i need

    hey guys and gals, have a 1990 chevy 350 from a suburban that was just given to me. i'm working on getting it into the cj5. i've been trying to find all the important items for the 350. it has a throttle body on it. you know the half carb, half fuel injection thing. i've taken all of the wiring...
  12. raser13

    chevy 350 wiring, what all do i need

  13. raser13

    chevy 350 pilot bearing/pushing help

    hey guys and gals, i have a chevy 350 out of a 1990 suburban that i got for free. it originally was attached to an auto trans. now it's going to be mated to my t-176 stick. what pilot bushing would i need? my jeep came with a 350 originally but it kept having issues. so i pulled that and...
  14. raser13

    chevy 350 pilot bearing/pushing help

  15. I

    76 CJ5 350 Swap, Skid plate/ cross member problems!!! Help!

  16. B

    Chevy 350

    Can anyone tell me if it matters where the heater hoses are connected? I have one coming out of the manifold and one out of the water pump. Thanks!
  17. B

    Chevy 350

  18. raser13

    Chevy 350 help

    Hey guys and gals, it's been a whole since I've been active here. My cj 5 has had a blown motor a 258 for some time now and has been sitting. We haven't had the money to get a new motor. But I've still been here watching in the shadows. But my luck has changed for the better. I responded to an...
  19. raser13

    Chevy 350 help

  20. B

    Wiring up chevy 350

    Ok,so i have been looking at posts for the last couple weeks on wiring for chevy 350 conversion. I'm looking for a dwg of some sort to help me and although i've seen alot of them i'm slightly confused. the motor is now installed and it looks like i have the same alternator as what is on the 350...
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks