play

  1. J

    Figured out my 1/4" axle end play

    Did a lot of searching and reading. Came across this little snippet of vital information on a Truetrac reseller's site. Same model number(912A579 Detroit Truetrac AMC 20 Rear). I bought my parts from Summit and they have no such note on their listing. Gonna get some 1-piece axles. 2-piece are a...
  2. J

    Axle flange snugged up. 1/4" play?

    AMC 20 stock axles. Can't remember how the axle felt before I removed it. I only used a slide hammer to back the axles out so I could install new gears. I put the axle back together and I can move the hub in and out about 1/4". The flange is definitely snugged up to the backing plate. Looks like...
  3. Bellworx

    How much play in 77 cj5 power steering

    Well I am upgrading my steering column from a non tilt to a tilt column. Got underneath the cj5 after removing it and was looking at the steering shaft. I figured since I am here might as well do an upgrade on the steering shaft. I noticed there is quite a bit of play in the shaft while twisting...
  4. El Jeep o

    Excessive play in shifter

    My T5 shifter has a lot of slop in it. from what I can tell the stick goes into a plastic "holder" or maybe its shims I really cant tell, at the transmisson. anyone know if that part is replaceable? any other ideas?
  5. El Jeep o

    Excessive play in shifter

  6. O

    amc 20 axle to bearing play excessive

    Has anyone found an outer axle bearing that was loose in the axle housing? I have that problem with the bearing race is loose in the axle housing. Bearing race is 2.55" outside diameter and the axle hole opening is 2.60". So the bearing race is .05 loose in the axle house. Certainly can't...
  7. O

    amc 20 axle to bearing play excessive

  8. V

    Steering wheel play

    Why the “play” in the upper part of the drive shaft? Video attached Thanks
  9. DaveMueller

    D20 Rear output shaft end play

    I'm rebuilding my D20 with the Novak kit. My first step in reassembly was the rear output cap. I need some help understanding the end play. I know how to measure it, but can't figure out what causes it. I pressed both bearing cups into the cap. Then front bearing onto the shaft. Then...
  10. DaveMueller

    D20 Rear output shaft end play

  11. V

    Play in steering

    On my 1981 CJ7, I got a play on the steering wheel to the right or left until it engages the wheels. Is it normal? 31” wheels
  12. Ultrunner

    Dana 300 End Play and springs

    I have two questions for the experts here. Installing my transfer case rear bearing cap, I started with the original number of shims (3) and then put on the cap, end bearing and yoke and toqued the retaining bolts to spec. The shaft was tight to turn, but not impossible, but there was no play. I...
  13. Ultrunner

    Dana 300 End Play and springs

  14. S

    Dana 300 rear output shaft end play

    I have finally gotten around to rebuilding my Dana 300 and have run into a problem regarding setting the end play on the rear output shaft. After assembling the shaft and getting an initial end play reading, .005, I added a .003 shim and remeasured the end play and got a .005 reading. So I...
  15. S

    Dana 300 rear output shaft end play

  16. J

    Np435 end play

    Just a little confused. Have a rebuilt np435 that I recently installed the Novak adaptor to adapt to the dana 20. Got the adaptor on (dry fitted) and torqued. Got the front input bearing retainer housing on with the input shaft (dry fitted) and torqued. I can't for the life of me figure out how...
  17. Greenwithenvy

    How many of you also play with snowmobles?

    Any body else getting their snowmobiles ready for the coming season? I have 2 older sleds that I play on. 97' 700 Yamaha mountain max, 02' 800 Skidoo Summit. Have miles of roads and wheat fields to play on. My driveway climbs 2000' in 4-1/2 miles, to my home. I live at about the 2700' level.
  18. Neuner

    Steering Box Input Shaft Play

    I have minor steering play and I've traced it down to what I think is the steering box input shaft. I'm assuming I need to replace it to get rid of the gap? In my online searches I came across a J20 steering box swap but it appeared to be for manual steering and some type of joint conversion...
  19. F

    play in wheel - repack or replace wheel bearings?

    I jacked up the cj the other day and noticed some play in the front passenger wheel (hands on top and bottom test). There is no noise or drag noticeable, just wondering if I need to order bearings or wait until I take it apart to see?
  20. F

    play in wheel - repack or replace wheel bearings?

    I jacked up the cj the other day and noticed some play in the front passenger wheel (hands on top and bottom test). There is no noise or drag noticeable, just wondering if I need to order bearings or wait until I take it apart to see?
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks