DIY Side Steps

DIY Side Steps
R

RiverD69

Jeeper
Posts
16
Thanks
0
Location
SC
Vehicle(s)
1985 Jeep CJ7, stock (for now). I-6 258, t-150 trans, dana 20 tc, 16" wheels with 285/75r16 BF Goodrich MT's.
1979 Jeep J10, stock (motor pulled for CJ7), t-150 trans, 15 x 10 Bullet hole wheels with Goodyear 31 x 10.5 r15 AT's, future sale or part out.
Anyone have any pics or plans for any DIY side steps? Would like to fab my own so that I know they'll be sturdy. Any help would be much appreciated.
 
I don't have plans but I did design my steps/sliders to match my Runck bumpers by using 3" square tubes cut at a 45 degree angle. I believe there are 2" square tubes going to plates where they are welded to the frame. I can't weld so a local club member did the work for me. Much cheaper (and better) than any I would have bought.

yva5ujyq.jpg


ryjahy6e.jpg



Dain
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a donation.

Help support Jeep-CJ.com by making a donation.
Goal
$200.00
Earned
$10.00
This donation drive ends in
Donate
Back
Top Bottom
✖
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks